RESUMO
The XANES/EXAFS data and quantum chemical simulations presented in this study demonstrate several features of the chemistry of arsenic compounds found in the condensates and solids generated in landfill gas (LFG) processing carried out for renewable natural gas (RNG) production. The XANES data show the decrease in the position of the absorption edge of As atoms, similar to that characteristic for sulfur-containing As solutes and solids. The EXAFS data show that the As-O and As-S distances in these matrixes are similar to those in thioarsenates. Quantum-chemical calculations demonstrated the close agreement between the experimental and modeled As-S and As-O distances determined for a range of methylated and thiolated arsenic solutes. These calculations also showed that the increase of the number of the As-S bonds in the coordination shell of arsenic is accompanied by a consistent decrease of the charges of As atoms. This decrease is correlated with the number of the As-S bonds, in agreement with the trend observed in the XANES data. These results provide insight into the intrinsic chemistry and reactivity of As species present in LFG matrixes; they may be helpful for the development of treatment methods to control arsenic in these systems.
RESUMO
Methylated arsenic species are ubiquitous in the environment and resistant to removal by conventional treatment technologies. This study addressed this challenge based on the examination of the removal of dimethylarsinic acid (DMA) in a system that combines zerovalent iron (ZVI) and powdered activated carbon (PAC). The removal of DMA in the ZVI/PAC system was compared to that by coagulation, adsorption, electrochemical and Fenton oxidations, and other conventional methods. While only the electrochemical oxidation using a PbO2/Sb-SnO2/Ti anode allowed removing up to 60% DMA at several hours-long treatment times, the removal of DMA in the ZVI/PAC system containing 10 g/L ZVI and 2.5 g/L PAC with an initial pH of 2.0 was 95% for a 30 min reaction time. Specific roles of PAC, ZVI and its oxidation products in DMA removal were examined based on the spectroscopic data and quantum chemical modeling for the DMA/Fe(II) and DMA/Fe(III) systems. These methods demonstrated the formation of moderately strong DMA/Fe(II) and DMA/Fe(III) complexation. These results and relevant kinetic data were interpreted to indicate that the removal of DMA is governed by the rapid generation of Fe2+ ions released as a result of accelerated ZVI corrosion in the galvanic ZVI/PAC microcells and ensuing formation of DMA/ Fe2+ complexes that are readily adsorbed by PAC.
RESUMO
Quantum-chemical study of structures, energies, and effective partial charge distribution for several models of the Rieske protein redox center is performed in terms of the B3LYP density functional method in combination with the broken symmetry approach using three different atomic basis sets. The structure of the redox complex optimized in vacuum differs markedly from that inside the protein. This means that the protein matrix imposes some stress on the active site resulting in distortion of its structure. The redox potentials calculated for the real active site structure are in a substantially better agreement with the experiment than those calculated for the idealized structure. This shows an important role of the active site distortion in tuning its redox potential. The reference absolute electrode potential of the standard hydrogen electrode is used that accounts for the correction caused by the water surface potential. Electrostatic calculations are performed in the framework of the polarizable solute model. Two dielectric permittivities of the protein are employed: the optical permittivity for calculation of the intraprotein electric field, and the static permittivity for calculation of the dielectric response energy. Only this approach results in a reasonable agreement of the calculated and experimental redox potentials.
